[IC]:SX1276
[Frequency]:862~930MHz
[Power]:20dBm
[Distance]:5.5km
[Size]:16*26mm
[Introduction]:E32-900T20S is a wireless serial port module (UART) based on SEMTECH's SX1276 RF chip. It has multiple transmission modes, working in the 862MHz~931MHz, LoRa spread spectrum technology, TTL output.
Pin No. | Pin Item | Pin Direction | Pin Application |
---|---|---|---|
1 | GND | - | Ground |
2 | GND | - | Ground |
3 | GND | - | Ground |
4 | GND | - | Ground |
5 | M0 | Input(weak pull-up) | With M1, the four working modes of the module can be determined (it cannot be suspended, and it can be grounded if it is not used). |
6 | M1 | Input(weak pull-up) | With M0, the four working modes of the module can be determined (it cannot be suspended, and it can be grounded if it is not |
7 | RXD | Input | TTL UART input ,Connect to external TXD output pins; Can be configured as drain open circuit or pull up input, see parameter Settings |
8 | TXD | Output | TTL UART output, Connect to external RXD input pin; Can be configured as drain open circuit or push - pull output, see parameter Settings |
9 | AUX | Output | Used to indicate the working status of the module; The user wakes up the external MCU and outputs low level during self-test initialization; Can be configured as drain open output, or push-pull output, see parameter Settings (can be suspended) |
10 | VCC | - | Positive reference of module power supply, voltage range: 2.3v ~ 5.2v DC |
11 | GND | - | Ground |
12 | NC | - | - |
13 | GND | - | Ground |
14 | NC | - | - |
15 | NC | - | - |
16 | NRST | - | - |
17 | NC | - | - |
18 | NC | - | - |
19 | GND | - | Ground |
20 | GND | - | Ground |
21 | ANT | - | Antenna |
22 | GND | - | Ground |